72V 120A Kelly Controller (Only Controller) For VNOM XTREME 11

72V 120A Kelly Controller (Only Controller)

 For VNOM XTREME 11

Note 

Due to adaptation issues, models equipped with this controller may have the following problems:
(1).Currently the fastest test speed is about 68mph.
(2).No brake lights.

(3).Need to adapt to the high rate of the battery, like we match the Samsung battery cell.

PARAMETERS INFO

-----

WEIGHT:0.8KGS

•Configurable battery voltage range, B+. Max operating range: 18V to 86V.
•Motor RMS Current, 1 minute boost: 60A.
•Motor RMS Current, continuous: 30A.

Features:

• Intelligence with powerful microprocessor.
• Synchronous rectification, ultra low drop, fast PWM to achieve very high efficiency.
• Electronic reversing.
• Voltage monitoring on 3 motor phases, bus, and power supply.
• Voltage monitoring on voltage source 12V and 5V.
• Current sense on all 3 motor phases.
• Current control loop.
• Hardware over current protection.
• Hardware over voltage protection.
• Configurable limit for motor current and battery current.
• Support torque mode, speed mode, and balanced mode operation.
• Low EMC.
• LED fault code.
• Battery protection: current cutback, warning and shutdown at configurable high and low battery voltage.
• Rugged aluminum housing for maximum heat dissipation and harsh environment.
• Rugged high current terminals, and rugged aviation connectors for small signal.
• Thermal protection: current cut back, warning and shutdown on high temperature.
• Configurable 60 degree or 120 degree hall position sensors.
• Support motors with any number of poles.
• Up to 40,000 electric RPM standard.
• Support three modes of regenerative braking: brake switch regen, release throttle regen, 0-5V analog signal variable regen.
• Configurable high pedal protection: the controller will not work if high throttle is detected at power on.
• Current multiplication: Take less current from battery, output more current to motor.
• Easy installation: 3-wire potentiometer will work.
• Standard PC/Laptop computer to do programming. No special tools needed.
• User program provided. Easy to use. No cost to customers.

General Specifications:

• Frequency of Operation: 16.6kHz.
• Standby Battery Current: < 0.5mA.
• 5V Sensor Supply Current: 40mA.
• Analog Brake and Throttle Input: 0-5 Volts. Can use 3-wire pot to produce 0-5V signal.
• Reverse Alarm, Meter: <200mA. Main Contactor Coil Driver<2A.
• Full Power Operating Temperature Range: 0℃ to 70℃ (MOSFET temperature).
• Operating Temperature Range: -40℃ to 100℃, (MOSFET temperature).
• Max Battery Current: Configurable.